May-15-2019, 03:28 PM
(This post was last modified: May-15-2019, 03:28 PM by punksnotdead.)
I wonder if anyone can give me some general advice on how to get set up as some weird things are happening
1. If I drag and drop a .py file into the standard command window (the DOS prompt one) the file sometimes runs ok but sometimes throws an error
2. If I then type python at the command prompt so i get >>> instead of > then try to drag and drop the file I get a unicodeescape error
3. However, I also have PyCharm installed. Should I just run using this and ditch the above. Or is there a better IDE than PyCharm?
As you can probably tell, I'm a newbie to Python and just want to get set up the best way
4. Are there any other tips I should bear in mind or implement
Thanks in advance, Mark
1. If I drag and drop a .py file into the standard command window (the DOS prompt one) the file sometimes runs ok but sometimes throws an error
2. If I then type python at the command prompt so i get >>> instead of > then try to drag and drop the file I get a unicodeescape error
3. However, I also have PyCharm installed. Should I just run using this and ditch the above. Or is there a better IDE than PyCharm?
As you can probably tell, I'm a newbie to Python and just want to get set up the best way
4. Are there any other tips I should bear in mind or implement
Thanks in advance, Mark