Python Forum

Hi guys!
I ran into some trouble programming a DIY LED panel that is attached to my Raspberry Pi 3.
The hardware setup is like this:

• a long stripe of WS2811 LEDs cut into pieces of 24 each
  
• 4 of these pieces arranged horizontally, making a 24x4 LED matrix
  
• the strips are soldered together on the left and right so they all get signal and power
  
• all done according to this tutorial: https://www.raspberrypi.org/forums/viewt...9&t=201753 with the exception that my panel is directly connected to the pi - no other hardware or power supply is necessary.
  

Since I'm completely new to python and all my research led me only to failures I want to ask you for advice. The setup I explained above is working perfectly fine. I just want the LED matrix to show something else than the "strandtest.py" has to offer: https://github.com/jgarff/rpi_ws281x/blo...andtest.py

I'm just unable to change the code to get the result that I want. The "strandtest.py" runs several test patterns, that look really nice, but I want:
A) Scroll any given text
B) display an audio spectrum analyzer based on sound input

Is that possible? Can you help me with that?

I made some humble progress and want to specify my problem a little further.
I installed the PIMODORI'S "unicornHAT" library:

curl https://get.pimoroni.com/unicornhat | bash

The scripts that came with it allow me to display example graphics on my DIY panel - so far so good.
The problem is, that I don't know how to customize the layout (from 8x8 to 24x4). The graphics are displayed fractured - of course - and only part of my panel is used.

Here is an example ("simple.py"). Can you help me customizing the code?

#!/usr/bin/env python

import time

import unicornhat as unicorn


print("""Simple

Turns each pixel on in turn and updates the display.

If you're using a Unicorn HAT and only half the screen lights up, 
edit this example and  change 'unicorn.AUTO' to 'unicorn.HAT' below.
""")

unicorn.set_layout(unicorn.HAT)
unicorn.rotation(0)
unicorn.brightness(0.5)
width,height=unicorn.get_shape()


for y in range(height):
  for x in range(width):
    unicorn.set_pixel(x,y,255,0,255)
    unicorn.show()
    time.sleep(0.05)

time.sleep(1)

You could perhaps write text in four pixels font

That's missing the point...
I can't address the panel properly - the image appears fractured.

Let me elaborate...

pi@raspberrypi:~ $ sudo ./rpi_ws281x/test -sgbr -x24 -y4 -g18 -c

Runs awesome! It generates a scrolling rainbow over the whole panel!
But I don't find a way to make it display stuff THAT I WANT...

In other folders, such as

pi@raspberrypi:~/Pimoroni/unicornhat/examples

There are a couple of cool example scripts that would really help me,
but they don't run over the whole panel and appear fractured!

How can I get these two together...?