Debugging a run job (Linux, python3, cython) - Printable Version +- Python Forum (https://python-forum.io) +-- Forum: Python Coding (https://python-forum.io/forum-7.html) +--- Forum: Homework (https://python-forum.io/forum-9.html) +--- Thread: Debugging a run job (Linux, python3, cython) (/thread-19139.html) |
Debugging a run job (Linux, python3, cython) - phycem - Jun-14-2019 I have a specific question about my python work. Could you have a look? I am running a research job in high energy physics but I have a problem with my output. My professor gave these files that I put the link below here. I ran them. Then I ran them again after doing some changes on them. I changed my original data in LL_line_cross_section.dat and BinnedSpectra_Matt.dat. But my output data was not changed: lim_ar_1.dat. If you can help me to solve this problem, I will be grateful to you. I am giving links to the files in Dropbox below there. I installed python 3 and cython on my ubuntu. Then opened those files in the second link on Ubuntu. I do run make.sh in likelihood folder first (>>>bash make.sh) but it requires an edit: >>>vi make.sh , change python to python3 in the file. Then I run the setup.py in analyses folder. I just wanted to give an overview of what I do to run in particular. At the end of two hours of running setup.py (>>>python3 setup.py), I get my output in analyses folder in the output directory. But I get the same output even though I change some files needed for output. And to run with my new files I renamed them where they have stated in the preload_spec.py file in likelihood directory where I put the links. This is the link to the new job I submitted with all of its preexisting and new BinnedSpectra...dat& LL_line_cross_section.dat and other newly created files after submission: https://www.dropbox.com/sh/rzoo3tc123wok24/AACd8KQ8H9HU-OxrdjKXOP-Qa?dl=0 This is the link for the original files without running them: https://www.dropbox.com/sh/sla7uyggok7isdc/AACX9U7VrZg9zUxVL4g_yPqea?dl=0 Thanks, Cemile Senem |