Making my way back into programming and need a little help.

[joegibbstruck]

So, the LEDs refer to my GPIO pins on the rasberry pi( it's a list of all 8 and I pull from that list which relay I want to do what) this is what I run to control the output for the relays( turn them on and off) I have to use what's called the LED board config on the PI because I need to be able to control multiple GPIO pins at once. I took all the LED stuff out , because without the GPIOzero library from the PI windows can't run this program.


I see what you are doing on most of this, I will check it out and try some of these suggestions. Thanks for that help and giving me a few things to try.